Repozitorij Univerze v Novi Gorici

Iskanje po repozitoriju
A+ | A- | Pomoč | SLO | ENG

Iskalni niz: išči po
išči po
išči po
išči po
* po starem in bolonjskem študiju

Opcije:
  Ponastavi


1 - 10 / 13
Na začetekNa prejšnjo stran12Na naslednjo stranNa konec
1.
Recommendations for reporting equivalent black carbon (eBC) mass concentrations based on long-term pan-European in-situ observations
Marjan Savadkoohi, Marco Pandolfi, Olivier Favez, Jean-Philippe Putaud, Konstantinos Eleftheriadis, Markus Fiebig, Philip Hopke, Paolo Laj, A. Wiedensohler, Griša Močnik, 2024, izvirni znanstveni članek

Opis: A reliable determination of equivalent black carbon (eBC) mass concentrations derived from filter absorption photometers (FAPs) measurements depends on the appropriate quantification of the mass absorption cross-section (MAC) for converting the absorption coefficient (babs) to eBC. This study investigates the spatial–temporal variability of the MAC obtained from simultaneous elemental carbon (EC) and babs measurements performed at 22 sites. We compared different methodologies for retrieving eBC integrating different options for calculating MAC including: locally derived, median value calculated from 22 sites, and site-specific rolling regression MAC. The eBC concentrations that underwent correction using these methods were identified as LeBC (local MAC), MeBC (median MAC), and ReBC (Rolling MAC) respectively. Pronounced differences (up to more than 50 %) were observed between eBC as directly provided by FAPs (NeBC; Nominal instrumental MAC) and ReBC due to the differences observed between the experimental and nominal MAC values. The median MAC was 7.8 ± 3.4 m2/g from 12 aethalometers at 880 nm, and 10.6 ± 4.7 m2/g from 10 MAAPs at 637 nm. The experimental MAC showed significant site and seasonal dependencies, with heterogeneous patterns between summer and winter in different regions. In addition, long-term trend analysis revealed statistically significant (s.s.) decreasing trends in EC. Interestingly, we showed that the corresponding corrected eBC trends are not independent of the way eBC is calculated due to the variability of MAC. NeBC and EC decreasing trends were consistent at sites with no significant trend in experimental MAC. Conversely, where MAC showed s.s. trend, the NeBC and EC trends were not consistent while ReBC concentration followed the same pattern as EC. These results underscore the importance of accounting for MAC variations when deriving eBC measurements from FAPs and emphasizes the necessity of incorporating EC observations to constrain the uncertainty associated with eBC.
Ključne besede: equivalent black carbon, mass absorption cross-section, filter absorption photometers, elemental carbon, absorption, site specific MAC, rolling MAC
Objavljeno v RUNG: 04.03.2024; Ogledov: 185; Prenosov: 3
.pdf Celotno besedilo (2,46 MB)
Gradivo ima več datotek! Več...

2.
Reducing carbon footprint by changing energy systems
Drago Papler, Marijan Pogačnik, 2022, objavljeni povzetek znanstvenega prispevka na konferenci

Ključne besede: energy efficiency, renewable energy barriers, energy efficiency, carbon footprint, economics
Objavljeno v RUNG: 08.01.2024; Ogledov: 468; Prenosov: 3
.pdf Celotno besedilo (14,88 MB)
Gradivo ima več datotek! Več...

3.
4.
Intervju s Simono Škrabec, prejemnico Lavrinove diplome
Simona Škrabec, Marjan Maček, Barbara Pregelj, 2020, intervju

Opis: intervju v Bukli s Simono Škrabec (intervjuvanka)
Ključne besede: prevajanje, Simona Škrabec, katalonščina, Lavrinova diploma
Objavljeno v RUNG: 05.01.2021; Ogledov: 2309; Prenosov: 0

5.
Effect of the Morphology of the High-Surface-Area Support on the Performance of the Oxygen-Evolution Reaction for Iridium Nanoparticles
Leonard Moriau, Marjan Bele, Živa Marinko, Francisco Ruiz-Zepeda, Gorazd Koderman, Martin Šala, Angelija Kjara Šurca, Janez Kovač, Iztok Arčon, Primož Jovanovič, Nejc Hodnik, Luka Suhadolnik, 2021, izvirni znanstveni članek

Opis: The development of affordable, low-iridium-loading, scalable, active, and stable catalysts for the oxygen-evolution reaction (OER) is a requirement for the commercialization of proton-exchange membrane water electrolyzers (PEMWEs). However, the synthesis of high-performance OER catalysts with minimal use of the rare and expensive element Ir is very challenging and requires the identification of electrically conductive and stable high-surface-area support materials. We developed a synthesis procedure for the production of large quantities of a nanocomposite powder containing titanium oxynitride (TiONx) and Ir. The catalysts were synthesized with an anodic oxidation process followed by detachment, milling, thermal treatment, and the deposition of Ir nanoparticles. The anodization time was varied to grow three different types of nanotubular structures exhibiting different lengths and wall thicknesses and thus a variety of properties. A comparison of milled samples with different degrees of nanotubular clustering and morphology retention, but with identical chemical compositions and Ir nanoparticle size distributions and dispersions, revealed that the nanotubular support morphology is the determining factor governing the catalyst’s OER activity and stability. Our study is supported by various state-of-the-art materials’ characterization techniques, like X-ray photoelectron spectroscopy, scanning and transmission electron microscopies, Xray powder diffraction and absorption spectroscopy, and electrochemical cyclic voltammetry. Anodic oxidation proved to be a very suitable way to produce high-surface-area powder-type catalysts as the produced material greatly outperformed the IrO2 benchmarks as well as the Ir-supported samples on morphologically different TiONx from previous studies. The highest activity was achieved for the sample prepared with 3 h of anodization, which had the most appropriate morphology for the effective removal of oxygen bubbles.
Ključne besede: electrocatalysis, oxygen-evolution reaction, TiONx-Ir powder catalyst, iridium nanoparticles, anodic oxidation, morphology−activity correlation
Objavljeno v RUNG: 04.01.2021; Ogledov: 2479; Prenosov: 0
Gradivo ima več datotek! Več...

6.
Z znanjem in izkušnjami v nove podjetniške priložnosti : zbornik izvlečkov
2016, druge monografije in druga zaključena dela

Ključne besede: zborniki, elektronske knjige
Objavljeno v RUNG: 13.05.2020; Ogledov: 2975; Prenosov: 21
URL Povezava na celotno besedilo
Gradivo ima več datotek! Več...

7.
Projekt predelave stroja za poliranje obročnih ključev
Jožef Petelinek, 2020, magistrsko delo

Opis: V magistrskem delu je opisana izvedba projekta predelave stroja za poliranje obročnih ključev. V prvem delu je opisano stanje stroja pred predelavo, razlogi za predelavo ter priprava zagonskega elaborata projekta predelave. V drugem delu je opisana izvedba projekta predelave. Ta zajema izdelavno nove električne vezalne sheme, izdelavo programa za krmilnik in operacijski panel, vezavo nove krmilne omare in vgradnjo teh komponent v omenjeni stroj. V zadnjem delu magistrskega dela je predstavljen postopek izdelave tehnične dokumentacije, potrebne za ponovni zagon stroja.
Ključne besede: avtomatizacija, stroj za poliranje, programabilni logični krmilnik, projektno vodenje, tehnična dokumentacija
Objavljeno v RUNG: 13.03.2020; Ogledov: 3322; Prenosov: 110
.pdf Celotno besedilo (2,29 MB)

8.
Synthesis of a Cu/ZnO Nanocomposite by Electroless Plating for the Catalytic Conversion of CO2 to Methanol
Maja Pori, Iztok Arčon, Damjan Lašič Jurković, Marjan Marinšek, Goran Dražić, Blaž Likozar, Zorica Crnjak Orel, 2019, izvirni znanstveni članek

Opis: The process of methanol synthesis based on the hydrogenation of CO2 was investigated over binary Cu/ZnO catalyst materials, prepared by applying a novel electroless plating fabrication method. The activity of the produced catalytic samples was determined at temperature range between 200 and 300 °C and the feedstock conversion data were supplemented with a detailed microstructure analysis using high-resolution transmission electron microscopy (HRTEM), X-ray powder diffraction (XRD) and Cu and Zn K-edge, X-ray absorption near-edge structure (XANES) measurements and extended X-ray absorption fine-structure (EXAFS) measurements. It was confirmed that the disorder in the Cu crystallites created unique geometrical situations, which acted as the additional reactive centres for the adsorption of the reactant molecule species. Copper and zinc structural synergy (spill-over) was also demonstrated as being crucial for the carbon dioxide’s activation. EXAFS and XANES results provide strong evidence for surface alloying between copper and zinc and thus the present results demonstrate new approach applicable for explaining metal–support interactions.
Ključne besede: EXAFS, CuZn alloy, Spillover mechanism, CO2 valorization, Electroless deposition method, Heterogeneous catalysis
Objavljeno v RUNG: 12.04.2019; Ogledov: 3505; Prenosov: 0
Gradivo ima več datotek! Več...

9.
Electrochemical dissolution of iridium and iridium oxide particles in acidic media : transmission electron microscopy, electrochemical flow cell coupled to inductively coupled plasma mass spectrometry and X-ray absorption spectroscopy study
Primož Jovanovič, Nejc Hodnik, Francisco Ruiz-Zepeda, Iztok Arčon, Barbara Jozinović, Milena Zorko, Marjan Bele, Martin Šala, Vid Simon Šelih, Samo B. Hočevar, Miran Gaberšček, 2017, izvirni znanstveni članek

Opis: Iridium based particles as the most promising proton exchange membrane electrolyser electrocatalysts were investigated by transmission electron microscopy (TEM), and by coupling of electrochemical flow cell (EFC) with online inductively coupled plasma mass spectrometer (ICP-MS). Additionally, a thin-film rotating disc electrode (RDE), an identical location transmission and scanning electron microscopy (IL-TEM and IL-SEM) as well as an X-ray absorption spectroscopy (XAS) studies have been performed. Extremely sensitive online time-and potential-resolved electrochemical dissolution profiles revealed that iridium particles dissolved already well below oxygen evolution reaction (OER) potentials, presumably induced by iridium surface oxidation and reduction processes, also referred to as transient dissolution. Overall, thermally prepared rutile type IrO2 particles (T-IrO2) are substantially more stable and less active in comparison to as prepared metallic (A-Ir) and electrochemically pretreated (E-Ir) analogues. Interestingly, under OER relevant conditions E-Ir particles exhibit superior stability and activity owing to the altered corrosion mechanism where the formation of unstable Ir(>IV) species is hindered. Due to the enhanced and lasting OER performance, electrochemically pre-oxidized E-Ir particles may be considered as the electrocatalyst of choice for an improved low temperature electrochemical hydrogen production device, namely a proton exchange membrane electrolyser.
Ključne besede: Iridium Oxide Par-ticles, Electrochemical Dissolution of Iridium, Ir L3-edge XANES
Objavljeno v RUNG: 23.08.2017; Ogledov: 3785; Prenosov: 0
Gradivo ima več datotek! Več...

10.
Atomically resolved dealloying of structurally ordered Pt nanoalloy as an oxygen reduction reaction electrocatalyst
Andraž Pavlišič, Primož Jovanovič, Vid Simon Šelih, Martin Šala, Marjan Bele, Goran Dražić, Iztok Arčon, Samo B. Hočevar, Anton Kokalj, Nejc Hodnik, Miran Gaberšček, izvirni znanstveni članek

Opis: The positive effect of intermetallic ordering of platinum alloy nanoparticles on oxygen reduction reaction (ORR) activity has been well established. What is still missing is an understanding of selective leaching of the less noble metal from the ordered structure and its correlation to longterm ORR performance. Using a combination of kinetic Monte Carlo simulations and advanced characterization techniques, we provide unprecedented insight into dealloying of intermetallic PtCu3 nanoparticles a well-known binary alloy. Comparison of ordered and disordered samples with identical initial compositions and particle size distributions reveals an unexpected correlation: whereas the copper dealloying rates in the ordered and disordered counterparts are almost the same, in the ordered structure Pt atoms are surrounded by 15−30% more Cu atoms throughout all the stages of acid leaching. This more convenient Pt−Cu coordination explains the statistically significant increase of 23−37% in ORR activity of the ordered structure at all stages of alloy degradation.
Ključne besede: ORR activity, fuel cells, platinum alloy, nanoparticle stability, intermetallic ordering, kinetic Monte Carlo, dealloying, in situ ICP-MS
Objavljeno v RUNG: 27.09.2016; Ogledov: 5527; Prenosov: 0
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.05 sek.
Na vrh