Search the repository

A+ | A- | | SLO | ENG

Keywords: polarimetric, stars, supernovae, AT 2018cow
Published in RUNG: 11.01.2024; Views: 469; Downloads: 2
Full text (1,30 MB)

Abstract: Abstract. Recent years have seen an increase in the use of wood for energy production of over 30 %, and this trend is expected to continue due to the current energy crisis and geopolitical instability. At present, residential wood burning (RWB) is one of the most important sources of organic aerosols (OA) and black carbon (BC). While BC is recognized for its large light absorption cross-section, the role of OA in light absorption is still under evaluation due to their heterogeneous composition and source-dependent optical properties. Studies that characterize wood-burning aerosol emissions in Europe typically focus on urban and background sites and only cover BC properties. However, RWB is more prevalent in rural areas, and the present scenario indicates that an improved understanding of the RWB aerosol optical properties and their subsequent connection to climate impacts is necessary for rural areas. We have characterized atmospheric aerosol particles from a central European rural site during wintertime in the village of Retje in Loški Potok, Slovenia, from 01.12.2017 to 07.03.2018. The village experienced extremely high aerosol concentrations produced by RWB and near-ground temperature inversion. The isolated location of the site and the substantial local emissions made it an ideal laboratory-like place for characterizing RWB aerosols with low influence from non-RWB sources under ambient conditions. The mean mass concentrations of OA and BC were 34.8 µg m-3 (max = 271.8 µg m-3) and 3.1 µg m-3 (max = 24.3 µg m-3), respectively. The mean total particle number concentration (10–600 nm) was 9.9 x 103 particles cm-3 (max = 53.5 x 103 particles cm-3). The mean total light absorption coefficient at 370 nm and 880 nm measured by an Aethalometer AE33 were 122.8 Mm-1 and 15.3 Mm-1 and had maximum values of 1103.9 Mm-1 and 179.1 Mm-1, respectively. The aerosol concentrations and absorption coefficients measured during the campaign in Loški Potok were significantly larger than those reported values for several urban areas in the region with larger populations and extent of aerosol sources. Here, considerable contributions from brown carbon (BrC) to the total light absorption were identified, reaching up to 60 % and 48 % in the near UV (370 nm) and blue (470 nm) wavelengths. These contributions are up to three times higher than values reported for other sites impacted by wood-burning emissions. The calculated mass absorption cross-section and the absorption Ångström exponent for RWB OA were MACOA, 370 nm= 2.4 m2 g-1, and AAEBrC, 370–590 nm= 3.9, respectively. Simple forcing efficiency (SFE) calculations were performed as a sensitivity analysis to evaluate the climate impact of the RWB aerosols produced at the study site by integrating the optical properties measured during the campaign. The SFE results show a considerable forcing capacity from the local RWB aerosols, with a high sensitivity to OA absorption properties and a more substantial impact over bright surfaces like snow, typical during the coldest season with higher OA emissions from RWB. Our study's results are highly significant regarding air pollution, optical properties, and climate impact. The findings suggest that there may be an underestimation of RWB emissions in rural Europe and that further investigation is necessary.
Keywords: wood-burning aerosols, optical characterization, black carbon, rural areas
Published in RUNG: 10.01.2024; Views: 485; Downloads: 6
Full text (1,99 MB)
This document has many files! More...

Abstract: The contribution of traffic and wood burning to particulate matter (PM) across the Alps is widely recognized and studied (Herich et al., 2014 and references therein; Glojek et al., 2020). However, studies on valleys with cement production are scarce (Kim et al., 2003; Rovira et al., 2018) despite its large PM emissions and potential toxic properties (Erik et al., 2022; Weinbruch et al., 2023). We aim to identify and characterize sources’ contribution to the complex mixture of carbonaceous and mineral PM10 in a representative Alpine valley. Quartz filter samples of PM10 were collected daily from December 2020 to December 2021 and analyzed using different chemical techniques. In the same period equivalent black carbon (eBC) measurements were taken with the Aethalometer AE43. The measured species were analyzed using Positive Matrix Factorization (PMF) model (EPA PMF 5.0) with newly added tracers, i. e. source-specific eBC (Sandradewi et al., 2008) and organic species (2-MT, 3-MBTCA, phtalic acid, MSA and oxalate). The final PMF results were compared to online PMF-factors (SoFi Pro) derived from PM10 and PM2.5 elemental measurements (Cooper Xact 625i). Ten factors were identified at the site, including commonly detected biomass burning, traffic, nitrate- and sulfate-rich, aged sea salt and mineral dust. With the added additional organic traces, primary biogenic and secondary oxidation were recognized as well. In addition, two unusual factors were disclosed, contributing 10% to annual PM10. Namely, Cl-rich and a mineral dust-rich factor, which we name the cement kiln factor. We associate these two factors to different processes in the cement plant. The outputs of the study provide vital information about the influence of cement production on PM10 concentrations in complex environments and are useful for PM control strategies and actions.
Keywords: PM pollution, carbonaceous aerosols, source apportionment, industry
Published in RUNG: 10.01.2024; Views: 552; Downloads: 0
This document has many files! More...

Keywords: audio forensics, tampering, signal processing
Published in RUNG: 09.01.2024; Views: 415; Downloads: 2
Link to file
This document has many files! More...

Keywords: thermal lens, thermal diffusivity, zinc oxide, graphene, nanofluid
Published in RUNG: 09.01.2024; Views: 485; Downloads: 2
Link to file
This document has many files! More...