Repository of University of Nova Gorica

Search the repository
A+ | A- | Help | SLO | ENG

Query: search in
search in
search in
search in
* old and bologna study programme

Options:
  Reset


1 - 4 / 4
First pagePrevious page1Next pageLast page
1.
A mechanistic study of metal sulfur batteries
Robert Dominko, Alen Vižintin, Sara Drvarič Talian, Ana Robba, Iztok Arčon, 2018, published scientific conference contribution abstract (invited lecture)

Keywords: Li-sulphur batteries, Sulphur XANES, magnesium
Published in RUNG: 15.10.2020; Views: 2313; Downloads: 0

2.
Role of Cu current collector on electrochemical mechanism of Mg–S battery
Ana Robba, Maja Mežnar, Alen Vižintin, Jan Bitenc, Jernej Bobnar, Iztok Arčon, Anna Randon-Vitanova, Robert Dominko, 2020, original scientific article

Abstract: Development of magnesium sulfur battery is accompanied with all known difficulties present in Li–S batteries, however with even more limited choice of electrolytes. In the present work, the influence of current collector on electrochemical mechanism was investigated in light of different reports where improved behavior was ascribed to electrolyte. Notable differences in cycling behavior are reported when Al current collector is replaced by Cu current collector independent of electrolyte. The initial reduction of sulfur follows similar reaction path no mater of current collector, but formation of MgS can be in competition with formation of CuS in the presence of Cu cations. With the subsequent cycling cells prepared from cathodes deposited on Cu current collector show decrease in the voltage and formation of single plateau during cycling. The change corresponds to the involvement of Cu into the reaction and formation of redox couple Mg/CuS as determined by Cu K-edge XANES measurements. Corrosion of Cu foil is identified by SEM and serves as a source of Cu cations for the chemical reaction between Cu and polysulfides. Mg/CuS redox couple shows improved cycling stability, but theoretical energy density is severely reduced due to substitution of S with CuS as cathode active material.
Keywords: Magnesium Sulfur Rechargeable batteries Current collector Copper Corrosion
Published in RUNG: 16.01.2020; Views: 2933; Downloads: 0
This document has many files! More...

3.
Sulfur based batteries studied by in-operando S K-edge RIXS and XAS spectroscopy
Matjaž Kavčič, Ana Robba, Janez Bitenc, Alen Vižintin, Iztok Arčon, Matjaž Žitnik, Klemen Bučar, Robert Dominko, 2018, published scientific conference contribution abstract

Abstract: Sulfur based batteries are considered as very attractive energy storage devices. Sulfur is one of the most abundant elements in the earth, it is electrochemically active material which can accept up to two electrons per atom. In combination with alkali metals, sulfur forms electrochemical couples with much higher theoretical energy density compared to Li-ion batteries commonly available today. At the moment, the electrochemical couple with Li is most extensively studied. While the main principle of operation is known the relevant operation mechanism(s) is not completely clear. Even more promising is the electrochemical couple with Mg providing almost twofold higher volumetric energy density due to its ability to provide two electrons during oxidation. However, Mg-S batteries are still in the very early stage of research and development and the complex mechanism of sulfur conversion has been less extensively studied. In order to improve the understanding of sulfur electrochemical conversion and its interactions within electrode, we need to apply new experimental approaches capable to provide precise information about local environment of S in the cathode during battery operation. In our work, resonant inelastic X-ray scattering (RIXS) and XAS measurements at the sulfur K-edge performed in operando mode were used to study the lithium-polysulfide formation during the discharge process. Measurements were performed at ID26 beamline of the ESRF synchrotron using tender X-ray emission spectrometer [1]. Resonant excitation condition enhanced the sensitivity for the lithium−polysulfide detection. On the other hand, the sulfate signal from the electrolyte was heavily suppressed and the self-absorption effects minimized due to fixed excitation energy. This experimental methodology was used to provide quantitative analysis of sulfur compounds in the cathode of a Li−S battery cell during the discharge process [2]. The high-voltage plateau in the discharge curve was characterized by a rapid conversion of solid sulfur into liquid phase Li polysulfides reaching its maximum at the end of this plateau. At this point the starting point for the precipitation of the Li2S from the liquid polysulfide phase was observed. The same approach has been used also for the Mg-S battery revealing similar mechanism as in case of Li-S battery [3]. The electrochemical conversion of sulfur with magnesium proceeds through two well-defined plateaus, which correspond to the equilibrium between sulfur and Mg polysulfides (high-voltage plateau) and polysulfides and MgS (low-voltage plateau).
Keywords: Mg-Sulphur batteries, XANES, RIXS
Published in RUNG: 13.09.2018; Views: 4378; Downloads: 0
This document has many files! More...

4.
A Mechanistic Study of Magnesium Sulfur Batteries
Ana Robba, Alen Vižintin, Jan Bitenc, Gregor Mali, Iztok Arčon, Matjaž Kavčič, Matjaž Žitnik, Klemen Bučar, Giuliana Aquilanti, Charlotte Martineau-Corcos, Anna Randon-Vitanova, Robert Dominko, 2017, original scientific article

Abstract: Magnesium sulfur batteries are considered as attractive energy storage devices due to the abundance of electrochemically active materials and high theoretical energy density. Here we report the mechanism of a Mg-S battery operation, which was studied in the presence of simple and commercially available salts dissolved in a mixture of glymes. The electrolyte offers high sulfur conversion into MgS in the first discharge with low polarization. The electrochemical conversion of sulfur with magnesium proceeds through two well-defined plateaus, which correspond to the equilibrium between sulfur and polysulfides (high-voltage plateau) and polysulfides and MgS (low-voltage plateau). As shown by XANES, RIXS and NMR studies, the end discharge phase involves MgS with Mg atoms in a tetrahedral environment resembling the wurtzite structure, while chemically synthesized MgS crystalizes in the rock-salt structure with octahedral coordination of magnesium.
Keywords: magnesium, sulfur, rechargeable batteries, XAS, NMR
Published in RUNG: 19.10.2017; Views: 4336; Downloads: 0
This document has many files! More...

Search done in 0.03 sec.
Back to top