1. Multicomponent Cu-Mn-Fe silica supported catalysts to stimulate photo-Fenton-like water treatment under sunlightAndraž Šuligoj, Ivalina Trendafilova, Ksenija Maver, Albin Pintar, Alenka Ristić, Goran Dražić, Wael H. M. Abdelraheem, Zvonko Jagličić, Iztok Arčon, Nataša Zabukovec Logar, Dionysios D. Dionysiou, Nataša Novak Tušar, izvirni znanstveni članek Ključne besede: Magnetic catalyst, Photocatalyst, Water treatment, Sunlight, Contaminants of emerging concern, Photo-Fenton-like systems, Cu, Mn, Fe, XANES, EXAFS Objavljeno v RUNG: 06.07.2023; Ogledov: 2479; Prenosov: 9 Celotno besedilo (4,32 MB) |
2. Correlations between photocatalytic activity and chemical structure of Cu-modified TiO2-SiO2 nanoparticle compositesT. Čižmar, doktorska disertacija Opis: The objective of this dissertation was to examine how copper modification can improve the photocatalytic activity of TiO2-SiO2 and to explain the correlation between Cu concentration and chemical state of Cu cations in the TiO2-SiO2 matrix, as well as the photocatalytic activity under the UV/solar irradiation.
The Cu-modified TiO2-SiO2 photocatalysts were prepared by a low temperature sol-gel method based on organic copper, silicon and titanium precursors with varied Cu concentrations (from 0.05 to 3 mol%). The sol-gels were dried at 150 °C to obtain the photocatalysts in the powder form. To test thermal stability, additional set of photocatalysts was obtained by calcinating dried samples in air at 500 °C for 1 h.
The photocatalytic activity was determined by a fluorescence-based method of terephthalic acid decomposition. Up to three times increase in photocatalytic activity of air-dried samples is obtained when TiO2-SiO2 matrix is modified with Cu in a narrow concentration range from 0.05 to 0.1 mol%. At higher Cu loadings the photocatalytic activity of Cu-modified photocatalyst is smaller than in the unmodified reference TiO2-SiO2 photocatalyst. Calcined samples showed significantly reduced photocatalytic activity compared to air-dried samples.
XRD analysis showed that all Cu-modified TiO2-SiO2 nanocomposites with different Cu concentrations have the same crystalline structure as unmodified TiO2-SiO2 nanocomposites (air-dried or calcined). The addition of Cu does not change the relative ratio between the anatase and brookite phase or unit cell parameters of the two TiO2 crystalline structures. TEM analysis showed that the addition of Cu does not change the morphology of TiO2-SiO2 catalyst dried at 150 °C.
The Cu K-edge XANES and EXAFS analysis were used to determine valence state and local structure of Cu cations in Cu-modified TiO2-SiO2 photocatalyst. The results elucidate the mechanism responsible for the improved or hindered photocatalytic activity. In the air-dried samples with low Cu content, which exhibit largest activity, Cu-O-Ti connections are formed, suggesting that the activity enhancement is due to Cu(II) cations attachment on the surface of the photocatalytically active TiO2 nanoparticles, so Cu(II) cations may act as free electron traps, reducing the intensity of recombination between electrons and holes at the TiO2 photocatalyst’s surface. At higher Cu loadings no additional Cu-O-Ti connections are formed, instead only Cu-O-Cu connections are established, indicating the formation of amorphous or nanocrystalline Cu(II) oxide, which hinders the photocatalytic activity of TiO2. Calcination of Cu-modified TiO2-SiO2 photocatalysts at 500 °C induces significant structural changes: Cu-O-Ti connections are lost, Cu partially incorporates into the SiO2 matrix and amorphous copper oxides, which again reduce the photocatalytic activity of the material, are formed. Ključne besede: titanium dioxide, Cu-modified TiO2-SiO2 photocatalyst, photocatalytic activity, Cu K-edge XANES, EXAFS. Objavljeno v RUNG: 17.12.2018; Ogledov: 5678; Prenosov: 159 Celotno besedilo (3,05 MB) |
3. Effects of Different Copper Loadings on the Photocatalytic Activity of TiO2-SiO2 Prepared at a Low Temperature for the Oxidation of Organic Pollutants in WaterT. Čižmar, Iztok Arčon, Mattia Fanetti, Urška Lavrenčič Štangar, 2018, izvirni znanstveni članek Opis: The objective of this research is to examine how Cu modification can improve the photocatalytic activity of TiO2-SiO2, to explainthe correlation between the Cu concentration and the chemical state of Cu cations in the TiO2-SiO2 matrix, and the photocatalytic activity under UV/solar irradiation. The Cu-modified TiO2-SiO2 photocatalysts were prepared by a low-temperature sol–gel method from organic Cu, Si and Ti precursors with various Cu concentrations (0.05–3 mol %). The sol–gels were dried at 150 8C to obtain the photocatalysts in a powder form. The photocatalytic activity was determined by using a fluorescence- based method of terephthalic acid decomposition. An up to three times increase in photocatalytic activity is obtained if the TiO2-SiO2 matrix is modified with Cu in a narrow concentration
range from 0.05 to 0.1 mol%. At higher Cu loadings,
the photocatalytic activity of the Cu-modified photocatalysts is lower than that of the un-modified reference TiO2-SiO2 photocatalyst. XRD was used to show that all Cu-modified TiO2-SiO2 composites with different Cu concentrations have the same crystalline structure as un-modified TiO2-SiO2 composites. The addition of Cu does not change the relative ratio between the anatase and brookite phases or unit cell parameters of the two TiO2 crystalline structures. We used Cu K-edge X-ray absorption near edge structure and extended X-ray absorption fine structure analyses to determine the valence state and local structure of Cu cations in the Cu-modified TiO2-SiO2 photocatalysts. The results elucidate the mechanism responsible for the improved photocatalytic activity. In samples with a low Cu content,
which exhibit the highest activity, Cu@O@Ti connections
are formed, which suggests that the activity enhancement is
caused by the attachment of CuII cations on the surface of the photocatalytically active TiO2 nanoparticles, so CuII cations may act as free-electron traps, which reduce the intensity of recombination between electrons and holes at the TiO2 photocatalyst surface. At higher Cu loadings no additional Cu@O@Ti connections are formed, instead only Cu@O@Cu connections are established. This indicates the formation of amorphous or nanocrystalline
copper oxide, which hinders the photocatalytic activity
of TiO2. Ključne besede: Cu modified TiO2-SiO2 photocatalyst
Cu EXAFS, XANES, Organic pollutants Objavljeno v RUNG: 30.08.2018; Ogledov: 4517; Prenosov: 0 Gradivo ima več datotek! Več... |
4. Surface modified titanium dioxide using transition metals : nickel as a winning transition metal for solar light photocatalysisAndraž Šuligoj, Iztok Arčon, Matjaž Mazaj, Goran Dražić, Denis Arčon, Pegie Cool, Urška Lavrenčič Štangar, Nataša Novak Tušar, 2018, izvirni znanstveni članek Opis: Titanium dioxide has been widely used as an antimicrobial agent, UV-filter and catalyst for pollution abatement. Herein, surface modifications with selected transition metals (Me) over colloidal TiO2 nanoparticles and immobilization with a colloidal SiO2 binder as composite films (MeTiO2/SiO2) on a glass carrier were used to enhance solar-light photoactivity. Colloidal TiO2 nanoparticles were modified by loading selected transition metals (Me ¼ Mn, Fe, Co, Ni, Cu, and Zn) in the form of chlorides on their surface. They were present primarily as oxo-nanoclusters and a portion as metal oxides. The structural characteristics of bare TiO2 were preserved up to an optimal metal loading of 0.5 wt%. We have shown in situ that metal-oxo-nanoclusters with a redox potential close to that of O2/O2 were able to function as co-catalysts on the TiO2 surface which was excited by solar-light irradiation. The materials were tested for photocatalytic activity by two opposite methods; one detecting O2 (reduction, Rz ink test) while the other detecting OH (oxidation, terephthalic acid test). It was shown that the enhancement of the solar-light activity of TiO2 by the deposition of transition metal oxo-nanoclusters on the surface depends strongly on the combination of the reduction potential of such species and appropriate band positions of their oxides. The latter prevented excessive self-recombination of the photogenerated charge carriers by the nanoclusters in Ni and Zn modification, which was probably the case in other metal modifications.
Overall, only Ni modification had a positive effect on solar photoactivity in both oxidation and reduction reactions. Ključne besede: surface modified TiO2, XANES, EXAFS, Nickel, solar light photocatalyst Objavljeno v RUNG: 01.06.2018; Ogledov: 4360; Prenosov: 0 Gradivo ima več datotek! Več... |