Iskanje po repozitoriju

A+ | A- | | SLO | ENG

Opis: Bi2O3-based pyrochlore nanomaterials and their photocatalytic, optoelectronic and crystallographic properties are the research topics of this doctoral dissertation. We synthesized these materials at nanoscale, since they are expected to possess photoactivity in the visible-light spectrum, which is an important target for the high-performance photocatalysts. To prepare nanoparticles that are not agglomerated, different synthesis methods (coprecipitation, coprecipitation followed by the digestion, reverse micelle) and post-treatments (furnace or hydrothermal reactor) were examined. Micrometer size materials were prepared with the solid-state reaction and annealing at high temperature. Bi2Ti2O7 nanoparticles were synthesized with the coprecipitation reaction, followed by annealing at 570 °C in the furnace or in the hydrothermal reactor at 230 °C for 18h in NH4OH medium. UV-Vis diffuse reflectance spectra of the Bi2Ti2O7 samples showed that they exhibit the maximum absorption edge at ~420-440 nm. The UV-Vis diffuse reflectance measurements of Bi2Ti2O7 loaded with 10 wt. % of Ag as a co-catalyst showed an enhanced absorbance in the visible region, presumably due to a contribution of Local Surface Plasmon Resonance. The Bi2Ti2O7 nanoparticles are not photocatalytically active under the visible light irradiation without assistance of a sacrificial reagent. The photocatalytic activity does not increase even with Ag as a co-catalyst under visible light irradiation. All samples are active under UV light irradiation, especially the sample with Ag that is able to decolourize 7 mg/L of metyl orange in just 3 min of exposure to UV light. However, H2O2 as a sacrificial reagent increases the photocatalytic activity of Bi2Ti2O7 under visible light irradiation. Phase pure pyrochlore Bi1.647Nb1.118Fe1.157O7 (BNF) nanoparticles were synthesized with coprecipitation reaction and further annealing in the furnace at 570 °C for 7h or 15h and in the hydrothermal reactor at 160 °C for 18h in 3 M or 6 M NaOH medium. The BNF materials exhibit shift toward longer wavelengths in absorbance of visible light (up to ~550-650 nm). This result confirmed that incorporation of Fe in the pyrochlore structure decreases the band gap. The BNF nanoparticles annealed for 7h showed intense photoactivity under visible light irradiation in the presence of a sacrificial reagent. The improved photoactivity, much better than with BNF, was shown for the composite nanoparticles BiOCl/BNF. They decolourize 100 % of the 7 mg/L methyl orange within only 2h of the visible light irradiation in the presence of H2O2. Phase pure pyrochlore Bi1.9Te0.58Fe1.52O6.87 (BTF) nanoparticles were synthesised by coprecipitation reaction and further annealing in the furnace at 570 °C for 7h. Although the BTF nanoparticles include higher amount of Fe than BNF nanoparticles and exhibit narrower band gap, the photoactivity of these nanoparticles is a bit lower than that of BNF nanoparticles. We assume that Fe at some critical concentration causes formation of mid-band states, which act as recombination centers. The same as BiOCl/BNF, the BiOCl/BTF composite is able to decolourize 100 % of the 7 mg/L MO within 2h of the visible light irradiation in the presence of H2O2. Based on the band gap determination and estimation of valence and conduction band levels, the proposed photodecolourization mechanisms are discussed. The conduction band levels of all synthesized materials lie more positively than O2/O2● redox potential (vs. negative hydrogen electrode potential), but are more close to H2O2/●OH redox potential. Thus, we assume that the photogenerated electrons form ●OH radicals, the species that induce dye decolourization under visible light irradiation. We believe that better performance of composite materials (BiOCl/BNF, BiOCl/BTF) is due to the formation of heterojunction, which facilitates the electron transfer between semiconductors, and O2 vacancy states formation in the BiOCl material.
Najdeno v: ključnih besedah
Povzetek najdenega: ...target for the high-performance photocatalysts. To prepare nanoparticles that are not agglomerated, different synthesis methods...
Ključne besede: nanoparticles, pyrochlore structure, photocatalysis, visible light
Objavljeno: 26.06.2015; Ogledov: 7281; Prenosov: 205
Polno besedilo (7,29 MB)

Opis: Fascinating packing patterns of identical spherical and discotic objects on curved surfaces occur readily in nature and science. Examples include C60 fullerenes,(1, 2)13-atom cuboctahedral metal clusters,(3) and S-layer proteins on outer cell membranes.(4) Numerous situations with surface-arranged objects of variable size also exist, such as the lenses on insect eyes, biomineralized shells on coccolithophorids,(5) and solid-stabilized emulsion droplets(6) and bubbles.(7) The influence of size variations on these packing patterns, however, is studied sparsely. Here we investigate the packing of nanosized silica particles on the surface of polystyrene latex particles fabricated by Pickering miniemulsion polymerization of submicrometer-sized armored monomer droplets. We are able to rationalize the experimental morphology and the nearest-neighbor distribution with the help of Monte Carlo simulations. We show that broadening of the nanoparticle size distribution has pronounced effects on the self-assembled equilibrium packing structures, with original 12-point dislocations or grain-boundary scars gradually fading out.
Najdeno v: ključnih besedah
Ključne besede: packing patterns, silica, simulation, Monte Carlo, order, disorder, transition, armored particles, nanoparticles, Pickering emulsion
Objavljeno: 10.10.2016; Ogledov: 3992; Prenosov: 0
Polno besedilo (3,85 MB)

Opis: A novel, simple method was developed to synthesize biocompatible composites containing 50% cellulose (CEL) and 50% keratin (KER) and silver in the form of either ionic (Ag+) or Ag0 nanoparticle (Ag+NPs or Ag0NPs). In this method, butylmethylimmidazolium chloride ([BMIm+Cl-]), a simple ionic liquid, was used as the sole solvent and silver chloride was added to the [BMIm+Cl-] solution of [CEL+KER] during the dissolution process. The silver in the composites can be maintained as ionic silver (Ag+) or completely converted to metallic silver (Ag0) by reducing it with NaBH4. Results of spectroscopy (Fourier-transform infrared (FTIR), X-ray diffraction (XRD)) and imaging (scanning electron microscope (SEM)) measurements confirm that CEL and KER remain chemically intact and homogeneously distributed in the composites. Powder X-ray diffraction (XRD) and SEM results show that the silver in the [CEL+KER+Ag+] and [CEL+KER+Ag0] composites is homogeneously distributed throughout the composites in either Ag+ (in the form of Ag2O nanoparticles (NPs)) or Ag0NPs form with size of (9 ± 1) nm or (27 ± 2) nm, respectively. Both composites were found to exhibit excellent antibacterial activity against many bacteria including Escherichia coli, Staphylococus aureus, Pseudomonas aeruginosa, methicillin resistant Staphylococus aureus (MRSA), vancomycin resistant Enterococus faecalis (VRE). The antibacterial activity of both composites increases with the Ag+ or Ag0 content in the composites. More importantly, for the same bacteria and the same silver content, [CEL+KER+Ag0] composite exhibits relatively greater antimicrobial activity against bacteria compared to the corresponding [CEL+KER+Ag+] composite. Experimental results confirm that there was hardly any Ag0NPs release from the [CEL+KER+Ag0NPs] composite, and hence its antimicrobial activity and biocompatibility is due, not to any released Ag0NPs but rather entirely to the Ag0NPs embedded in the composite. Both Ag2ONPs or Ag0NPs were found to be toxic to human fibroblasts at higher concentration (>0.72 mmol), and that for the same silver content, [CEL+KER+Ag2ONPs] composite is relatively more toxic than [CEL+KER+Ag0NPs] composite. As expected, by lowering the Ag0NPs concentration to 0.48 mmol or less, the [CEL+KER+Ag0NPs] composite can be made biocompatible while still retaining its antimicrobial activity against bacteria such are E. coli, S. aureus, P. aeruginosa, MRSA, VRE. These results together with our previous finding that [CEL+KER] composites can be used for controlled delivery of drugs such as ciprofloxacin clearly indicate that the [CEL+KER+Ag0NPs] composite possess all required properties for successfully used as high performance dressing to treat chronic ulcerous infected wounds.
Najdeno v: ključnih besedah
Povzetek najdenega: ...either Ag+ (in the form of Ag2O nanoparticles (NPs)) or Ag0NPs form with size of...
Ključne besede: Celulose, Keratin, Cmposites, Biocompatible, Ag nanoparticles, one-pot synthesis, Antibacterial, Antiviral
Objavljeno: 28.11.2016; Ogledov: 4285; Prenosov: 0
Polno besedilo (2,04 MB)

Opis: Two plant pathogenic fungi, Botrytis cinerea and Alternaria alternata, isolated from crop plants, were exposed to Cu in ionic (Cu2þ), microparticulate (MP, CuO) or nanoparticulate (NP, Cu or CuO) form, in solid and liquid culturing media in order to test fungal response and toxic effects of the mentioned compounds for the potential use as fungicides. B. cinerea has shown pronounced growth and lower levels of lipid peroxidation compared to A. alternata. Its higher resistance/tolerance is attributed mainly to biotransformation of CuO and Cu NPs and CuO MPs into a blue compound at the fungal/culturing media interface, recognized by Cu K-edge EXAFS analysis as Cu-oxalate complex. The pronounced activity of catechol-type siderophores and organic acid secretion in B. cinerea induce leaching and mobilization of Cu ions from the particles and their further complexation with extracellularly secreted oxalic acid. The ability of pathogenic fungus to biotransform CuO MPs and NPs hampers their use as fungicides. However the results show that B. cinerea has a potential to be used in degradation of Cu(O) nanoparticles in environment, copper extraction and purification techniques.
Najdeno v: ključnih besedah
Ključne besede: copper, metal oxide nanoparticles, detoxification mechanisms, metal pollution, Cu-oxalate
Objavljeno: 23.08.2017; Ogledov: 3597; Prenosov: 0
Polno besedilo (1,52 MB)

Opis: A novel, one-pot method was developed to synthesize gold nanoparticle composite from cellulose (CEL), wool keratin (KER) and chloroauric acid. Two ionic liquids, butylmethylimmidazolium chloride and ethylmethylimmidazolium bis(trifluoromethylsulfonyl)imide were used to dissolve CEL, KER and HAuCl4. X-ray diffraction and X-ray photoelectron results show that Au3+ was completely reduced to Au0NPs with size of (5.5 ± 1) nm directly in the composite with NaBH4. Spectroscopy and imaging results indicate that CEL and KER remained chemically intact and were homogeneously distributed in the com- posites with Au0NPs. Encapsulating Au0NPs into [CEL+KER] composite made the composite fully biocom- patible and their bactericidal capabilities were increased by the antibacterial activity of Au0NPs. Specifically, the [CEL+KER+Au0NPs] composite exhibited up to 97% and 98% reduction in growth of antibi- otic resistant bacteria such as vancomycin resistant Enterococcus faecalis and methicillin resistant Staphylococcus aureus, and was not cytotoxic to human fibroblasts. While [CEL+KER] composite is known to possess some antibacterial activity, the enhanced antibacterial observed here was due solely to added Au0NPs. These results together with our previous finding that [CEL+KER] composites can be used for con- trolled delivery of drugs clearly indicate that the [CEL+KER+Au0NPs] composites possess all required properties for successful use as dressing to treat chronic ulcerous infected wounds.
Najdeno v: ključnih besedah
Povzetek najdenega: ...Ionic liquid Green Sustainable Polysaccharide Keratin Wound dressing Gold nanoparticles Antibiotic-resistant bacteria...
Ključne besede: Ionic liquid Green Sustainable Polysaccharide Keratin Wound dressing Gold nanoparticles Antibiotic-resistant bacteria
Objavljeno: 27.09.2017; Ogledov: 3638; Prenosov: 0
Polno besedilo (2,44 MB)