Repository of University of Nova Gorica

Search the repository
A+ | A- | Help | SLO | ENG

Query: search in
search in
search in
search in
* old and bologna study programme

Options:
  Reset


1 - 10 / 36
First pagePrevious page1234Next pageLast page
1.
Performance analysis of high-spectral-resolution lidar with/without laser seeding technique for measuring aerosol optical properties
Fengjia Gao, Fei Gao, Gaipan Li, Fan Yang, Li Wang, Song Yuehui, Dengxin Hua, Samo Stanič, 2024, original scientific article

Abstract: High-spectral-resolution lidar (HSRL) is a powerful tool for aerosol measurements. With/without laser seeding technique in the transmitted laser, the HSRL can be distinguished as the single-longitudinal-mode (SLM) HSRL or the multi-longitudinal-mode (MLM) HSRL, and the Mach-Zehnder interferometer (MZI) with periodic transmittance function can be used as the spectral discriminator in both the SLM HSRL and MLM HSRL. To in-depth knowledge of the respective advantages of the SLM HSRL and MLM HSRL for measuring aerosol optical properties, the working principle, optimal parameter setting, and detection performance of the SLM HSRL and MLM HSRL are analyzed and discussed in detail, respectively. The working principle of the SLM HSRL and MLM HSRL indicate that the effective transmittance of MZI is the important parameter of data retrieval, the main source of retrieval uncertainties, and the key factor of MZI optical path difference (OPD) settings. To ensure that the MZI can achieve the preferable separation for aerosol Mie scattering signals and molecular Rayleigh scattering signals, the optimal OPDs of MZI are set at 165 mm and 1000 mm in the SLM HSRL and MLM HSRL from the aspects of the effective transmittance of MZI and the spectral discrimination ratio (SDR). Besides, to analyze the influence of frequency difference and divergence angle for the detection performance of HSRL, the effective transmittance of MZI and SDR are simulated and the results show that the MLM HSRL has higher requirements for the environmental parameters and the echo beam collimation than the SLM HSRL. Moreover, the HSRLs with SLM and MLM transmitted lasers are constructed in Xi'an for measuring aerosol optical properties. The preliminary measurement results show that the range square corrected signal (RSCS) of Rayleigh channel is smaller than that of Mie channel in both the SLM HSRL and MLM HSRL, while the difference between RSCS of Rayleigh channel and RSCS of Mie channel in the SLM HSRL is larger than that in the MLM HSRL, and the detection range of the SLM HSRL is lower than that of the MLM HSRL.
Keywords: aerosol optical properties, high-spectral-resolution lidar, single-longitudinal-mode, multi-longitudinal-mode, spectral discrimination ratio
Published in RUNG: 28.02.2024; Views: 228; Downloads: 2
URL Link to file
This document has many files! More...

2.
Aerosol complex refractive index retrieval in the Paris urban area and its forested surroundings during the ACROSS field campaign : variability and constraint for direct radiative effect estimation in regional models
Ludovico Di Antonio, Griša Močnik, 2023, published scientific conference contribution abstract

Abstract: The complex refractive index (CRI) is one of the key parameter driving aerosol spectral optical properties and direct radiative effects (DRE). Its value and spectral variation under different conditions, such as anthropogenic− and biogenic−dominated environments and anthropogenic−biogenic mixing situations, remains not fully understood. As a consequence, oversimplified representations of aerosol optical properties are generally used in climate models. Therefore, measurements of aerosol CRI in different environments and their inclusion in models are needed. The field observations from the ACROSS campaign, performed in June-July 2022 in the Ile de France region, are used in this study to deepen the knowledge of aerosol optical properties, aiming to improve the aerosol representation in the CHIMERE model and provide the best constraint for DRE simulations. Measurements obtained both at the Paris city center and the Rambouilllet rural forest sites during ACROSS are considered, in order to explore the CRI variability from anthropogenic−dominated to biogenic−dominated environments, including anthropogenic−biogenic mixing situations. The CRI retrievals at seven different wavelengths, performed by combining the Mie theory with optical and size distribution measurements, are representative of different atmospheric conditions, aerosol loadings as well as type and chemical compositions. In fact, the June-July 2022 period was characterized by highly diversified weather conditions: 1) two strong heatwaves, promoting SOA build-up and favoring the export of the Paris pollution plume towards the forest site; 2) Saharan dust events transported from the upper atmosphere to the ground; 3) biomass burning episode; 4) periods with reduced anthropogenic influence. The CRI retrievals under these different conditions and their link to particulate chemical composition is investigated. Hence, the CRI dataset presented here constitutes a unique dataset from which models can benefit to validate and constrain simulations and DRE estimations, under both urban and biogenic emissions influence. These data, in conjunction with those from the aircraft observations during ACROSS, are used to initialize and perform sensitivity studies on the aerosol DRE, using the CHIMERE−WRF coupled model, the OPTSIM model for the aerosol optical properties and the Rapid Radiative Transfer Model for GCMs (RRTMG).Keywords: Complex refractive index, direct radiative effect, aerosol mixing, urban, forest
Keywords: aerosol optical properties, refractive index
Published in RUNG: 21.12.2023; Views: 508; Downloads: 2
.pdf Full text (293,28 KB)

3.
Infrared spectra in amorphous alumina : a combined ab initio and experimental study
Luigi Giacomazzi, Nikita S. Shcheblanov, Mikhail E. Povarnitsyn, Yanbo Li, Andraž Mavrič, Barbara Zupančič, Jože Grdadolnik, Alfredo Pasquarello, 2023, original scientific article

Abstract: We present a combined study based on the experimental measurements of an infrared (IR) dielectric function and first-principles calculations of IR spectra and the vibrational density of states (VDOS) of amorphous alumina (am−Al2O3). In particular, we show that the main features of the imaginary part of the dielectric function ε2(ω) at ∼380 and 630 cm−1 are related to the motions of threefold-coordinated oxygen atoms, which are the vast majority of oxygen atoms in am-Al2O3. Our analysis provides an alternative point of view with respect to an earlier suggested assignment of the vibrational modes, which relates them to the stretching and bending vibrational modes of AlOn (n=4, 5, and 6) polyhedra. Our assignment is based on the additive decomposition of the VDOS and ε2(ω) spectra, which shows that (i) the band at ∼380cm−1 features oxygen motions occurring in a direction normal to the plane defined by the three nearest-neighbor aluminum atoms, i.e., out-of-plane motions of oxygen atoms; (ii) Al-O stretching vibrations (i.e., in-plane motions of oxygen atoms) appear at frequencies above ∼500cm−1, which characterize the vibrational modes underlying the band at ∼630cm−1. Aluminum and fourfold-coordinated oxygen atoms contribute uniformly to the VDOS and ε2(ω) spectra in the frequency region ∼350–650 cm−1 without causing specific features. Our numerical results are in good agreement with the previous and presently obtained experimental data on the IR dielectric function of am−Al2O3 films. Finally, we show that the IR spectrum can be modeled successfully by assuming isotropic Born charges for aluminum atoms and fourfold-coordinated oxygen atoms, while requiring the use of three parameters, defined in a local reference frame, for the anisotropic Born charges of threefold-coordinated oxygen atoms.
Keywords: dielectric properties, microstructure, amorphous materials, density functional calculations, infrared techniques, aluminium oxide
Published in RUNG: 10.05.2023; Views: 1118; Downloads: 6
URL Link to full text
This document has many files! More...

4.
A comparative study of nanolaminate CrN/Mo2N and CrN/W2N as hard and corrosion resistant coatings
Marco Beltrami, Andraž Mavrič, Simone Dal Zilio, Mattia Fanetti, Gregor Kapun, Marco Lazzarino, Orfeo Sbaizero, Miha Čekada, 2013, original scientific article

Abstract: Nanolaminate coatings (NLC) consisting of alternated CrN coupled with either cubic tungsten nitride (β-W2N) or molybdenum nitride (γ-Mo2N) were deposited on cold worked tool steel substrates using reactive DC reactive magnetron sputtering for improved mechanical and corrosion resistance. The CrN/γ-Mo2N and CrN/β-W2N nanolaminate systems were found to perform better than the corresponding single-layer systems, with both mechanical and electrochemical properties improving by decreasing the individual layer thickness from 100 to 5 nm. The CrN/β-W2N NLC combined the high hardness value of W2N with the low corrosion current of CrN. The CrN/γ-Mo2N NLC showed synergistic improvements consisting of both higher hardness and lower corrosion currents with respect to the constituent materials alone. The dependence of mechanical and corrosion properties on the bilayer period is discussed in terms of the grain size, residual stresses and texture of the constituent materials and the nanostructured character of the multilayer architecture.
Keywords: Nanolayered coatings, Transition metal nitrides, Sputtering, Nanoindentation, Corrosion resistance, Mechanical properties
Published in RUNG: 12.01.2023; Views: 1088; Downloads: 0
This document has many files! More...

5.
6.
7.
8.
9.
10.
Search done in 0.06 sec.
Back to top