201. Photoelectrochemical activation of peroxymonosulfate using Sn-doped ▫$α-Fe_2O_3$▫ thin film for degradation of anti-inflammatory pharmaceutical drugManel Machreki, Georgi Tyuliev, Dušan Žigon, Qian Guo, Takwa Chouki, Ana Belén Jorge Sobrido, Stoichko Dimitrov, Saim Emin, 2024, original scientific article Abstract: Introduction of oxygen vacancies (OVs) has been investigated as a promising way to improve the electrical and catalytic characteristics of a hematite (α-Fe2O3) based photoelectrode. In this work, we develop a novel method for preparing porous Sn-doped α-Fe2O3 (Sn:Fe2O3) thin films with intrinsic OVs. The procedure included spin- coating an iron precursor onto a fluorine-doped tin oxide (FTO) substrate, followed by thermal treatment at elevated temperatures. The influence of Sn dopant on the optoelectronic properties of α-Fe2O3 was demonstrated by X-ray photoelectron spectroscopy and photoelectrochemical (PEC) measurements. The combined effect of OVs and Sn doping was found to play a synergistic role in reducing the charge recombination’s. The Sn:Fe2O3 photoanodes were used as a dual catalyst to oxidise water and break down an anti-inflammatory drug called 2-(4- isobutylphenyl)propanoic acid (IBPA). The Sn:Fe2O3 thin film with a 30-minute heat treatment time displayed the highest incident photon-to-current efficiency. For the first time, Sn:Fe2O3 thin films were utilised in the effective PEC degradation of IBPA employing peroxymonosulfate (PMS) under visible light illumination. The hydroxyl radicals (•OH), singlet oxygen (1O2), photogenerated holes (h+), and sulfate radicals (SO4 • ) were discovered to be the main reactive species during PEC degradation. IBPA degradation and the formation of new compounds were verified using liquid chromatography-mass spectrometry. The Lepidium sativum L phytotoxicity test reveals that PEC-treated wastewater with IBPA exhibits decreased toxicity. Keywords: Sn-doped Fe2O3, oxygen vacancies, photoelectrochemical degradation, 2-(4-isobutylphenyl)propanoic acid, peroxymonosulfate Published in RUNG: 10.01.2024; Views: 497; Downloads: 7 Full text (2,44 MB) This document has many files! More... |
202. Identification and detailed characterization of ▫$PM_10$▫ sources in an Alpine valley influenced by a cement plantKristina Glojek, Katja Džepina, Griša Močnik, 2023, published scientific conference contribution abstract Abstract: The contribution of traffic and wood burning to particulate matter (PM) across the Alps is widely recognized and studied (Herich et al., 2014 and references therein; Glojek et al., 2020). However, studies on valleys with cement production are scarce (Kim et al., 2003; Rovira et al., 2018) despite its large PM emissions and potential toxic properties (Erik et al., 2022; Weinbruch et al., 2023). We aim to identify and characterize sources’ contribution to the complex mixture of carbonaceous and mineral PM10 in a representative Alpine valley.
Quartz filter samples of PM10 were collected daily from December 2020 to December 2021 and analyzed using different chemical techniques. In the same period equivalent black carbon (eBC) measurements were taken with the Aethalometer AE43. The measured species were analyzed using Positive Matrix Factorization (PMF) model (EPA PMF 5.0) with newly added tracers, i. e. source-specific eBC (Sandradewi et al., 2008) and organic species (2-MT, 3-MBTCA, phtalic acid, MSA and oxalate). The final PMF results were compared to online PMF-factors (SoFi Pro) derived from PM10 and PM2.5 elemental measurements (Cooper Xact 625i).
Ten factors were identified at the site, including commonly detected biomass burning, traffic, nitrate- and sulfate-rich, aged sea salt and mineral dust. With the added additional organic traces, primary biogenic and secondary oxidation were recognized as well. In addition, two unusual factors were disclosed, contributing 10% to annual PM10. Namely, Cl-rich and a mineral dust-rich factor, which we name the cement kiln factor. We associate these two factors to different processes in the cement plant.
The outputs of the study provide vital information about the influence of cement production on PM10 concentrations in complex environments and are useful for PM control strategies and actions. Keywords: PM pollution, carbonaceous aerosols, source apportionment, industry Published in RUNG: 10.01.2024; Views: 625; Downloads: 0 This document has many files! More... |
203. |
204. |
205. |
206. |
207. |
208. |
209. Where is iron? : depth binding profiles in Chelex resin hydrogels using diffusive gradients in thin films - beam deflection spectrometry methodDorota Korte, Hanna Budasheva, Mohanachandran Nair Sindhu Swapna, Sankaranarayana Iyer Sankararaman, Arne Bratkič, 2023, published scientific conference contribution abstract Keywords: iron, Chelex resin, diffusive gradients, thin films, beam deflection spectrometry Published in RUNG: 09.01.2024; Views: 490; Downloads: 2 Link to file This document has many files! More... |
210. |