Search the repository

A+ | A- | | SLO | ENG

Abstract: Earth’s atmosphere is a complex system. All weather phenomena take place in its lowest layer, the troposphere, which is strongly influenced by human activities and the underlying surface orography. A good example of the influence the orography has on the behavior of air flows is the appearance of strong north-east downslope wind in Vipava valley, called Bora. Numerical models used to analyze flows in complex terrain need meteorological data both for setting the initial conditions and the verification of modeling results. Obtaining spatial distributions of meteorological observables can be challenging, especially in the case of strong winds, such as Bora, where traditional methods may be inadequate due to prohibitive wind speeds. In most cases, vertical properties of the atmosphere can be obtained using remote sensing techniques. Contrary to vertical profile measurements with traditional methods, remote sensing techniques do not require the measuring device to be placed within the flow and are therefore more appropriate for measurements in severe weather conditions such as strong winds. The aim of this thesis is a detailed analysis of wind and tropospheric structure properties in and above the Vipava valley in a variety of typical atmospheric conditions, including strong wind events. It employs a combination of high resolution wind and lidar data in addition to standard meteorological measurements. In Ajdovščina, there are four predominant wind directions, two of them directly connected to Bora. In the case of Bora, periodicity analysis of wind data from Ajdovščina yielded a range of possible wind gust periods between 1 and 7 minutes. The periods were not stable, with the periodogram less noisy for stable wind directions. Wavelike structures were found to be present in the troposphere in half of the investigated cases, regardless of the presence of Bora. In statically stable conditions, gravity waves propagated throughout the planetary boundary layer (PBL). In the case of Bora, the PBL experienced oscillations with periods between 1 and 2 minutes. A shear layer was present above the PBL, causing Kelvin-Helmholtz waves at its boundaries with periods ranging from 3 to 6 minutes. In some cases, periodic structures were observed above the shear layer as well, which were found to have longer periods than those within the PBL.
Keywords: remote sensing, Vipava valley, wind properties, Bora, wind gusts, wind periodicity, tropospheric structures, Kelvin-Helmholtz waves
Published in RUNG: 18.09.2017; Views: 6561; Downloads: 199
Full text (45,11 MB)

Published in RUNG: 21.07.2017; Views: 5003; Downloads: 0
This document has many files! More...

Abstract: The Vipava valley in Slovenia is well known for the appearance of strong, gusty North-East Bora winds, which occur as a result of air flows over an adjacent orographic barrier. There are three revealing wind directions within the valley which were found to give rise to specific types of atmospheric structures. These structures were investigated using a Mie scattering lidar operating at 1064 nm, which provided high temporal and spatial resolution backscatter data on aerosols, which were used as tracers for atmospheric flows. Wind properties were monitored at the bottom of the valley and at the rim of the barrier using two ultrasonic anemometers. Twelve time periods between February and April 2015 were selected when lidar data was available. The periods were classified according to the wind speed and direction and investigated in terms of appearance of atmospheric structures. In two periods with strong or moderate Bora, periodic atmospheric structures in the lidar data were observed at heights above the mountain barrier and are believed to be Kelvin–Helmholtz waves, induced by wind shear. No temporal correlation was found between these structures and wind gusts at the ground level. The influence of the wind on the height of the planetary boundary layer was studied as well. In periods with low wind speeds, the vertical evolution of the planetary boundary layer was found to be governed by solar radiation and clouds. In periods with strong or moderate Bora wind, convection within the planetary boundary layer was found to be much weaker due to strong turbulence close to the ground, which inhibited mixing through the entire layer.
Keywords: Downslope wind Lidar observations Kelvin–Helmholtz waves Bora
Published in RUNG: 06.01.2017; Views: 5359; Downloads: 0
This document has many files! More...

Abstract: Li-S batteries are considered as one of the most promising candidates for future batteries in applications where high energy density is required [1]. Despite that the general principle of operation is known for a long time [2], the lack of detailed understanding of relevant operation mechanisms has so far prevented their extensive use. A Li-S battery is composed of a lithium metal anode and a sulfur based cathode, separated by a porous separator wetted with electrolyte. During the battery cycle the reduction and oxidation of S to Li2S and back proceeds through a complicated equilibrium mixture of compounds that are typically dissolved in the electrolyte in the form of long and short chain polysulfides. In order to improve our understanding of polysulfide formation and its interactions within electrode, which are essential to achieve the long term cycling stability, development and application of new analytical tools is required. In this work sulfur K-edge resonant X-ray emission (RXES) measurements were performed on the Li-S battery in operando mode. The experiment was performed at the ID26 beamline at ESRF using the Johansson type tender x-ray emission spectrometer [3]. Full K-L RIXS maps were recorded on a set of chemically prepared Li2Sx sample standards characterized by different Li:S stoichiometric ratio, followed by the operando measurements on Li-S battery. Using the spectra recorded on Li2Sx standards two excitation energies were chosen and RXES spectra from the back of the battery cathode were sequentially acquired during one discharge cycle (C20). The relative amounts of each sulfur compound in the cathode during the discharge cycle were determined from the linear combination fit using measured reference standard spectra. Because of resonant excitation conditions the sensitivity for the polysulfide detection was significantly enhanced. Our work sets up S K-edge RIXS spectroscopy as an important analytical tool to study the mechanism of Li-polysulfide formation in the cathode and their interaction with the host matrix and electrolyte.
Keywords: RIXS, RXES, Li-S battery, operando, Sulphur K-edge XANES, Lithium polysulphides, Li2S
Published in RUNG: 28.06.2016; Views: 5683; Downloads: 0
This document has many files! More...

Keywords: lidar, atmosferske strukture, vremenske razmere
Published in RUNG: 03.05.2016; Views: 5021; Downloads: 0
This document has many files! More...